TGIS-SL Calibration & Measurement Verification

October 12, 2012


Position Calibration & Measurement Verification Wheel 

Click here to find out why setup and maintenance costs in the final finishing operation are reduced with the use of the Tire Geometry Inspection System calibration device.

This device is for use with any TGIS Geometry System installed on ASTEC® uniformity machines, AkroDYNE™ dynamic balance machines, legacy D70 uniformity machines and FD90 uniformity machines. This device ensures the correct measurements and alignment between multiple TGIS equipped machines, allowing for the sharing of recipes.

Click here to contact a Micro-Poise sales representative today for details or email micropoise.csdsales@ametek.com.